Enhanced dielectric and nonohmic properties of SrTiO3-modified CaCu3Ti4O12 ceramics

Dielectric and nonohmic properties of CaCu₃Ti₄O₁₂ (CCTO) ceramics can be modified by addition of SrTiO₃ (STO) in different molar proportions which were fabricated by a modified sol-gel method. XRD results indicated that all modified ceramics showed mixed phase consisting of both CCTO and STO. SEM images and grain size distribution probability also presented the change of microstructure with the addition of STO. The dielectric loss of the CCTO/0.4STO ceramics sintered at 1000 °C can be lower than 0.02 in a wide frequency (1 kHz–10 kHz), especially at 1 kHz, the dielectric loss of this sample is as low as 0.012. Furthermore, excellent nonlinear I–V electrical characteristic (high breakdown voltage to 54.15 kV/cm for CCTO/0.4STO sintered at 1000 °C) was observed as well. All the results indicated that the addition of STO does improve the dielectric properties and nonohmic characteristics of CCTO ceramics dramatically.     

大型偏心结构吊装欠约束问题研究

吊装施工过程中被吊模块的水平度是作业要求的重要指标,通常需要增加配重调平。传统有限元方法需要补充约束以消除单元刚体位移,且需要重复计算平衡方程来求解调平载荷,效率不高。将模块的运动分解为随动坐标系的整体运动以及相对该坐标系的弹性变形,可将欠约束问题化为多体系统的静平衡问题。基于虚功率原理推导了吊装平顺时刻的节点力平衡方程以及相应的切线刚度矩阵,并将配重表示为基础配重与载荷系数相乘的形式。通过对节点力平衡方程求导,得到一组以载荷系数为自变量的微分方程,通过求解微分方程并结合水平度判据,可快速搜寻满足水平度要求的载荷系数。数值算例表明,该方法在解决偏心模块吊装欠约束问题方面具有明显的优势,在确定配重载荷方面具有较快的速度和合理的精度。     

微氧化烧结制备掺杂Y2O3的SiC陶瓷及含镉模拟废水处理

采用了微氧化烧结制备了不同Y₂O₃质量分数（0%、2%、4%、6%）的多孔SiC陶瓷，通过对陶瓷的晶体结构、微观形貌、物理性能和Cd²⁺的去除率测试发现：添加了Y₂O₃的SiC陶瓷出现了较多的第二相Y₂SiO₇、Y₅Si₃C_0.5，随着Y₂O₃的质量分数增加逐渐升高，主相的衍射峰的强度有降低。扫描电子显微镜测试发现，SiC陶瓷的尺寸在2.5 μm，Y₂O₃引入后，SiC陶瓷的晶粒尺寸降低，高温烧结时液相的含量增加，熔体粘度降低，晶粒结合更加紧密，Y₂O₃的引入提高了多孔陶瓷的体积密度，Y₂O₃质量分数为6%SiC的体积密度最大为2.21 g/cm³。热导率随着Y₂O₃质量分数的增加呈现出先升高后降低的趋势。金属Cd²⁺的过滤测试表明：随着Y₂O₃质量分数增加，Cd²⁺的残留质量浓度、膜通量和去除率先降低后升高，当掺杂质量分数为4%时，Cd²⁺残留质量浓度最低为0.042 mg/L，膜通量达到了最大值572 L/（m²·h），去除率最大为99.95%，相比未掺质量分数杂体系的去除率提高了0.14%。随着溶液pH值的逐渐增大，金属Cd²⁺的残留质量浓度逐渐降低、去除率逐渐升高，pH≥9时最终均趋于稳定。综合来看，多孔SiC陶瓷的助烧剂Y₂O₃最佳掺量为4%。     

Electrografting of amino-TEMPO on graphene oxide and electrochemically reduced graphene oxide for electrocatalytic applications

4-Amino-2,2,6,6-tetramethyl-1-piperridine N-oxyl (4-amino-TEMPO), an electroactive nitroxide radical, was attached to the surface of graphene oxide (GO) and electrochemically reduced graphene oxide (ERGO) modified glassy carbon electrode by a simple, rapid and green electrografting method. The electroactive interfaces were analyzed by X-ray photoelectron spectroscopy (XPS) and cyclic voltammetry (CV). The calculated surface coverage for 4-amino-TEMPO is up to 1.55 × 10^− 9 mol·cm^− 2. The modified electroactive interface exhibited excellent electrocatalytic activity towards the electro-oxidation of reduced glutathione (GSH) and hydrogen peroxide (H₂O₂).     

Porous inorganic filler Li4.7Ag1.63GeS4.8 in PEO electrolyte effectively inhibits Li dendrites for all-solid-state Li metal batteries

The newly created porous inorganic particles Li_4.7Ag_1.63GeS_4.8 as filler are added into poly (ethylene oxide) (PEO) with LiTFSI salt, which greatly improves the electrochemical stability of solid-state PEO-based electrolytes against Li metal in a working battery. Due to many pores and channels in the filler, Li dendrites would grow along these channels thereby effectively inhibiting their fast spread in PEO matrix and retarding the short circuit on account of the penetration of Li dendrite. The Li⁺ conductivity of this solid-state electrolyte membrane could be 1.36 × 10^-4 S/cm at 40 °C. The fabricated symmetrical Li metal cells could cycle above 550 h at 0.05 mA/cm² and corresponding LiFePO₄/Li all-solid-state cells have an excellent cycling stability of 160.65 mAh g^-1 specific capacity after 200 cycles with 99.93% columbic efficiency at 50 °C environment.     

Preparation of superhydrophobic composite paper mulching film

To study the influence of different concentrations of zinc oxide (ZnO)/silicon dioxide (SiO₂) composite coating on hydrophobic property and mechanical stability of paper mulch film, three kinds of ZnO/SiO₂ composite coating paper mulch films (2%, 4%, 6%) with different coating substance contents were prepared by brush coating method. Through particle size analysis, contact angle, rolling angle and mechanical stability test, combined with scanning electron microscope, three-dimensional morphology and roughness measuring instrument, the optimal concentration of ZnO/SiO₂ composite coated paper mulch film was screened out. Through acid-base salt corrosion test, silver mirror reaction and surface self-cleaning, the optimal concentration of composite coated paper mulch film was compared with the original paper mulch film to prove its excellent chemical stability and hydrophobicity. The results show that the paper mulch film with 4% coating material has excellent hydrophobicity and mechanical stability, can effectively reduce the surface roughness of paper mulch film, and has remarkable effects in resisting acid, alkali and salt and self-cleaning.     

含有2,4-二卤代联苯基的新型唑类衍生物的合成及其抗真菌活性

以2,4-二卤代联苯为原料,经傅-克酰基化、还原、取代等反应步骤,合成了含有2,4-二卤代联苯基的新型唑类目标化合物3a~3k,其结构用红外光谱(IR)、高分辨质谱(HMRS)、核磁共振氢谱(¹H NMR)、核磁共振碳谱(¹³C NMR)等技术手段进行了表征。 测试了目标化合物的体外抗真菌活性,结果表明,所有目标化合物对所测试的致病真菌均有一定程度的抗真菌活性。 其中化合物3a~3k对红色发癣菌和石膏样毛癣菌的抗真菌活性和两性霉素B相当,化合物3b、3c、3e、3f、3h、3i、3k对白色念珠菌的抗真菌活性优于或等于酮康唑。     

A single-step HSS method for non-Hermitian positive definite linear systems

In this paper, based on the Hermitian and skew-Hermitian splitting (HSS) iteration method, a single-step HSS (SHSS) iteration method is introduced to solve the non-Hermitian positive definite linear systems. Theoretical analysis shows that, under a loose restriction on the iteration parameter, the SHSS method is convergent to the unique solution of the linear system. Furthermore, we derive an upper bound for the spectral radius of the SHSS iteration matrix, and the quasi-optimal parameter is obtained to minimize the above upper bound. Numerical experiments are reported to the efficiency of the SHSS method; numerical comparisons show that the proposed SHSS method is superior to the HSS method under certain conditions.